If 9-11 was an Inside Job then How Did the Towers Collapse? Here is One Strong Possibility

Thermite Identified As Culprit Of WTC Collapse Would have been hot enough to melt steel and cause implosion

Paul Joseph Watson/Prison Planet.com | April 24 2006

A new branch of 9/11 research claims to have identified the cause of the collapse of the twin towers. The photographic and video evidence makes a very strong case for thermite being responsible for the unprecedented implosions of steel framed reinforced buildings on September 11.

Brigham Young University physicist Professor Steven Jones told peers at a Utah meeting that, "while almost no fire, even one ignited by jet fuel, can cause structural steel to fail, the combination of thermite and sulfur "slices through steel like a hot knife through butter."

Jones points to a video (click here to watch) which shows a bright yellow molten substance dripping from the south tower minutes before its collapse. Government investigators claimed that this was aluminum from Flight 175 but Jones is adamant that aluminum is silvery in appearance and doesn't turn yellow.

Jones also told the Deseret News that sulfur traces found at ground zero indicates the thermite was combined with sulphur to make it burn even hotter than the normal 2500 degrees Celsius.

Jones stated that thermite was a "clever" choice because its ingredients, aluminum and iron oxide do not require identifying tags by law, meaning they couldn't be traced back to their manufacturers.

Watch the following video and observe how thermite completely melts a car engine in a matter of seconds, without the addition of sulphur, and also completely resists neutralization by liquid nitrogen. Notice how the dripping substance is identical to that seen in the south tower video.

CLICK HERE TO WATCH THE VIDEO

The following video highlights the fact that steaming hot molten metal was still being found at the World Trade Center site six weeks after the attack.

CLICK HERE TO WATCH THE VIDEO

Jones also, "cited video pictures showing white ash rising from the south tower near the dripping, liquefied metal. When thermite burns, Jones said, it releases aluminum-oxide ash. The presence of both yellow-white molten iron and aluminum oxide ash "are signature characteristics of a thermite reaction," he said."

American Free Press writer Christopher Bollyn discusses evidence of thermite used to sever the twin tower's steel support columns in the picture below.


"In this photo, for example, the column directly above the fireman's helmet shows that it was cut with thermite. There is a substantial amount of hardened molten iron which can be seen on both the inside and outside of the box column. This is precisely what one would expect to find on a column which had been cut with thermite," says Bollyn.

White flames consistent with how thermite reacts producing molten iron and aluminum oxide are also visible in this photograph at the corner of the 81st floor of the south tower.



The USGS Spectroscopy Lab produced images which showed dense thermal hot spots days and weeks after the attacks. ABC News reported that, "the temperature at the core of "the pile," is near 2000 degrees Fahrenheit, according to fire officials, who add that the fires are too deep for firefighters to get to."



The What Really Happened website created a page giving more proof that thermite was used and how it runs parallel with eyewitness reports of explosions and pieces being sheered off the towers. An additional video shows white smoke (pictured) at the base of the north tower moments before its collapse. White smoke also rose from the wreckage of the towers.








It is now all but conclusive that the master architects of 9/11 used thermite to implode the towers, going the extra length to pull off the pyrotechnic horror show and enhance the media spectacle of 'the new Pearl Harbor,' instilling greater fear and fealty that enabled them to subsequently enact their domestic and geopolitical agenda.